How to Replace a Kia Sportage Replacement Key
For a number of Kia models, the key contains a built-in keyless entry system. This key is similar to an remote control, and can be exchanged with a Kia dealer.
Key fobs might stop working for several reasons, including a dead coin battery worn buttons signals, signal interference, water damage, and a defective receiver module. Here are some suggestions to assist you in getting your kia picanto spare key sportage replacement key working again.
How do you replace the remote key or smart key
The battery inside your Kia’s smart key will eventually require to be replaced, whether it’s a remote key, a push-to-start key or a regular metal key that doesn’t contain an electronic transponder. This is particularly when the car displays a message that the smart or remote key is not powered by the battery.
This is a relatively simple process. To replace the battery on the key fob remove the mechanical key from the hole in the back of the key fob. Next, remove the cover. A small screw is in the key fob to hold the battery in the correct position. Take out the old battery by removing the screw with the help of a small screwdriver. Insert the new battery and then close the cut on the key fob.
Test the key fob by pressing the lock and unlock buttons. You’re in good shape If the doors lock and unlock as expected. You can now make use of 2014 kia forte key fob‘s hands-free lock/unlock function when your fingers are cold or you have to make errands in Brandon.
Not all keys may require to be programmed (transponder chips or smart keys). This requires a specific programming machine that only the dealer or locksmith has access to. Other keys (non-transponder metal keys) don’t require programming. If your keys need to be reprogrammed, you must know the key code number printed on the tag that identifies the key and then record it in a safe place.
How do you replace a dead battery?
If your 2013 kia optima key fob programming key fob isn’t responding to pressing the lock or unlock button on the fob, it is a signal that the battery should be replaced. A low battery may also cause other problems like the check engine light flashing on or delayed engine cranking. Fortunately, replacing the battery on the key fob is a fairly simple DIY project that requires only the most basic tools.
Before you begin ensure that your vehicle is off and all doors are closed. Find the small metal or plastic piece at the bottom of the key fob. Then, jiggle it until the key falls out. This key can be placed inside the driver door handle to unlock your car.
To replace the battery on the key fob remove the cover on the rear. Make use of a plastic pry tool to open the latch that holds the black negative cable. Remove the old battery, and then orient the replacement battery to ensure its “+” side is facing you and the “-” negative side is facing the fob’s electrical contacts. Avoid using too much force when pushing the new CR2032 into place to avoid damaging or breaking the metal contacts.
Once the new battery is installed after which you turn the key fob off and then turn it on in the ignition until the door locks cycle. You can then test your Kia’s key fob again to make sure it is working correctly.
How do you replace a smart keys
Depending on the model of your 2014 Kia Optima Key Fob Sportage, you may have a standard key fob or a smart key. The smart key is equipped with an embedded mechanical key blade, unlike the standard key fob, which does not. Both types of key fobs have a battery inside them that will eventually have to be replaced. Fortunately, this is quite simple and will take about two minutes.
Be sure to turn off your Kia and stand on a level, well-lit surface before you begin. Keep in mind that the fob is made up of tiny pieces that could be thrown off in the event of a mishap.
The small release button is located on the lower backside. It will be a circular button or rectangular slot. Once you press this, the mechanical key blade will appear and you will be able to open the key fob.
Once you have the key fob open then you can remove the old battery and replace it. The new battery should be a CR-2032 and can be bought online or from your local auto parts store. When you’re done, the key fob will allow you to lock or unlock and start your vehicle, even if it isn’t running.
How do I replace a mechanical key
The Kia key fob is an amazing feature that lets us lock and unlock our car at the push of one button. As with all devices like a key fob, the Kia might have issues. There are ways to troubleshoot these issues and ensure that our key fobs are in good working order in the long run.
One of the most frequent issues is a low or dead battery. This can cause the device to stop working completely or stop working at times. If this is the problem then replace the battery with an entirely new battery.
If this does not resolve the problem, use an ordinary screwdriver with a flat head to push the fob’s casing made of plastic open. Be cautious not to damage any internal components or scratch the plastic. Once open, carefully remove the battery that was removed and replace it with a new one.
Close and open the door with the mechanical key. (Every Kia fob comes with an emergency mechanical key that fits into the slot). Test the key fob to ensure it’s functioning correctly. Contact a dealer locksmith to solve the issue when the fob still is not working. Make sure they make you an emergency key that works in all the trunk and door cylinders, to avoid future lockouts.
